I come out to see it myself
When you call, I'm the one who comes out to look, not a salesperson. Our masons do the work, and I'm on site to check it, so the person who wrote your estimate is the one making sure it gets done the way we said.
Masonry Contractor in Bridge City, TX - Brick Repairs That Blend In
We're a Beaumont masonry crew fixing cracked brick, crumbling mortar, leaky chimneys and settled slabs on Bridge City homes. We also build the brick fences, walkways and fireplaces people want next.
(409) 240-0376
What we see on Bridge City houses
We're based in Beaumont, and Bridge City is one of the cities around it where we take repair calls. Most of them are the ordinary wear on brick houses: a crack stepping up the wall from a corner, mortar joints that turn to sand when you rub them, or a chimney that's started to leak.
I want to know why the crack showed up before we patch it, because a crack over a moving slab comes right back if all you do is fill it. The rest of our work here is new building, like brick fences along the property line, walkways and outdoor kitchens. On those jobs, where the wall can legally sit matters as much as how it's built.
Get a free on-site estimate for your Bridge City masonry job
We reply to Bridge City calls and messages within one business day, and the estimate is free with no obligation. I come out to look at the job myself, then send you a written estimate after the visit.
(409) 240-0376Masonry work we do in Bridge City
Most calls here start with a repair, like brick repair, tuckpointing or a chimney that lets water in, and we match your brick and mortar so the fix blends in. We also build new, from brick walls and walkways to fireplace installation inside the house.
- Foundation repair
- Chimney repair
- Tuckpointing
- Brick repair
- Driveway pavers
- Retaining wall construction
- Masonry restoration
- Fireplace installation
- Stone veneer installation
- Concrete block walls
- Foundation block wall installation
- Outdoor kitchen masonry
- Walkway construction
- Brick wall installation
- Stone masonry
- Brick pointing
Permits, licenses and pricing for Bridge City jobs
In Bridge City, permits come from the city's Community Development office, which also handles inspections and contractor licensing. It issues building permits to build, enlarge, alter, repair or tear down a structure inside the city limits, so if your job needs one, that wait comes before our first day on site. The city requires most contractors to hold a City of Bridge City license, and you can check on that by calling the city at 409-735-6801. If your job needs a permit, I'll tell you at the estimate and we'll help get it in place before we start.
Price here turns on the same things it does in Groves or anywhere around Beaumont: how much brick has to come out, how hard your old brick and mortar are to match, and whether the real problem is the slab underneath. The schedule turns on the permit, if there is one, and on how soon we can find a matching brick. The written estimate I send after the visit puts your own figure on it.
Why Bridge City homeowners call us
Repairs that blend in with your brick
We're best known for brick, mortar and chimney repairs that match what's already there. We match the size, color and texture of your brick and the color of your mortar, so a repaired wall doesn't look patched from the street.
A small fix when a small fix will do
I care about fixing whatever caused the problem, not covering it up, and I'd rather tell you a small repair will do than sell you a big one. If a few bricks and some fresh mortar solve it, that's what your estimate says.
Licensed, insured and tidy at your house
We're fully licensed and insured, and we've been doing this since 2013. We keep the mess small and treat your house like it's ours, with satisfaction guaranteed on every job. Call (409) 240-0376 or use the form to set up a visit.
Questions we hear in Bridge City
How much does masonry repair cost in Bridge City, TX?
It depends on the job, so I give you a written figure after I've looked at it in person. Resetting a few bricks or repointing a short run of mortar costs far less than rebuilding a chimney or correcting a slab, and old brick that's hard to match adds to the bill. If a small repair will do, I'll say so before you spend money on a big one.
What causes cracks in brick walls on a Bridge City house?
Most brick cracks come from movement in the slab or footing under the wall, or from worn-out mortar that lets the bricks shift. A crack that steps up the joints near a corner or over a window usually points to movement, while crumbling joints all over point to tired mortar. I figure out which before we fix anything, because filling a crack without fixing its cause just means you'll be calling about it again.
Do I need a permit for foundation repair in Bridge City, TX?
Yes, the city lists slab correction among the work that needs a permit and inspections. After work starts, a city inspector checks that it meets local and state codes. A permit is issued to the person or company named on it and can't be transferred, and it's void if work doesn't start within 180 days.
Can I build a brick fence in my front yard in Bridge City?
Not in the front 25-foot setback, the strip along the front of your lot, and not in an easement, according to the city's permit form. On a corner lot, the corner setback is 15 feet and the height limit is 8 feet. Fences also need a permit and inspection, so we settle where the wall can go before we dig the footing.
How do I schedule a building inspection in Bridge City?
Call 409-474-3110 or email bviator@bridgecitytex.com to request one. Requests made before 10:30 a.m. are done the same business day, and later ones the next business day between 8 and 11 a.m. The city keeps these details on its permits and licenses page.
Do I need a floodplain permit for masonry work in Bridge City?
If the work sits in one of the city's special flood hazard areas, yes, the city requires a Floodplain Development Permit so the work meets its flood rules. Those areas come from FEMA's flood maps for Orange County, which mark the places at highest flood risk. Before we plan a new wall or slab, we check with the city on where your address falls.
How long does it take to get masonry work started in Bridge City?
It mostly depends on whether your job needs a permit. I come out, look at the job and send a written estimate, and if a permit is needed, we help get it in place before we start, which can add time. Once work begins, our masons do it and I'm on site checking.